Poulsbo, WA

Kitsap County






Vessel name: Free to Be - Seattle

Registration Number: unknown

Vessel Type: Unknown

Vessel Subtype: Sailing

Vessel is: Afloat

Vessel Secured: Anchored

Description of Any Hazardous Materials: unknown

Is Vessel Occupied?: No

Other Information: Vessel was reported to be in Liberty Bay for over a year before August 2023. Vessel was tagged by DNR on 8-25-23 and there has been no responses to date (1-30-24).


08/25/2023 | 12:00 pm

Tidal Overview

2 hours 15 minutes before high tide

Data from Poulsbo, Liberty Bay (0.3 miles away)

High Tide (Predicted): 2:15 pm, 9.5'

Observed Predicted water level Report time

Weather Overview

Wind Speed: 7.3 MPH

Wind Direction: ESE (120°)

Temperature: 67℉

Rainfall (Calendar Day): 0.01"

Rainfall (Past 24 Hours): 0"

(Click here for full weather details)




3 Comments. Leave new

  • 1/29/2024 – This vessel appears to be taking on water (possibly rain) and is sitting very low in the water.

  • Solenne Walker
    January 30, 2024 6:04 pm

    Reported to KCSO on 1/30. They will contact Jared Hofer, as needed and check in/pump out or remove the vessel. Vessel owner is unknown. DNR has not had any calls or responses from posting the vessel for trespass on state-owned aquatic lands in August 2023.

  • Thomas Rose
    June 11, 2024 6:56 pm

    This vessel is now sitting 1.5″ below its design waterline … prior photos show the bobstay fitting above the water … now it’s submerged. The mast spreaders have totally rotted off … and the upper topmast is rotten … the deck, deck house, and cabin is now almost “organic” … with debris and growth all over. The interior is strewn with garbage, cans and who knows. The Dacron anchor warp has slipped the bow sheave and is wedged in between. NOTE: Please don’t let this vessel linger until it sinks like the one off Fjord Drive/Lemolo shore … that bears at low water but is marked with a single worn orange ball fender so jet skis and recreational folk don’t run into it. I can forward updated photos.

You must be logged in to post a comment.